The Next Generation
STACS 200
Communications
Integration Hub
®


STACS® 200 Architecture
Network Architecture
-
All endpoints, including Operations Center support any combination of INMARSAT BGAN, VSAT, Cellular and CAT 5 backhaul, deployed as appropriate
-
System supports redundant field systems with a single group of Operations Center Digital Interface Ports (failover between the two systems), or two sets of Digital Interface Ports (concurrent operation)
-
All network traffic is transferred using AES-256/GCM encryption with RSA-4096 PKI key transfer (RSA used only for over the air keying of all systems)
-
Optional cellular and INMARSAT terminals on Operations Center system maintain system operation in case of DDOS or internet infrastructure (DNS, etc) attack
Rapid Deployment
-
Field systems only require opening the case, connecting the radios and pressing the power switch to initiate cellular operation
-
Automatic selection of two cellular carriers (including Google Fi for international operation)
-
INMARSAT BGAN terminal require approximately 2 minutes for setup and connection, link between satellite terminal and case can be Cat 5 or wireless
-
Simple touch-screen interface for status and basic management
Power Options
-
AC operation, 90-260V 50/60 hz, international plug adapters included
-
DC operation, 10-36VDC with reverse and over-voltage protection to 150V
-
Dual internal batteries with fully redundant operation and built-in configurations available up to 48 hours of worst-case power consumption
-
System can be charged with case closed and can be stored with charger connected with external charge state / fault indicator
-
Batteries can be field-swapped while the system is operational
System Options
-
Field systems have 4 expansion slots, one of which is consumed by a four port Digital Radio Adapter
-
Any combination of sensor interfaces (Area-Rae CBRNE, Smith, etc), Digital and Analog Radio interfaces can be used in the three available slots supporting up to 16 radios
-
Three Cat 5 LAN ports are provided for Notebooks, VOIP phones, WiFi Access Points, etc. Devices can be Internet connected or connected to Operations Center network via VPN
Maintenance & Management
-
All configuration and management operations can be performed on any of the remote systems or the Operations Center system via a Browser/Web Interface
-
All configuration operations can be performed even when a device is not powered on. The device will automatically upload the updated configuration when connected
-
Each system proactively monitors battery charge and health, even when powered off. Systems will automatically power up briefly to send a management alert when a battery fault is detected, or the battery charge dips below configurable thresholds (50 and 25% by default)
-
Systems can be stored with their cases sealed and an external charger connected indefinitely.
-
Systems will maintain 80% of available charge when stored between 50 and 90 degrees F for three months without external charger connected




